Packed in 16-WFQFN Exposed Pad, CSP, the electronic component is convenient for shipping overseas. This packaging method provides high reliability because it uses advanced packaging techniques. Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 2:1 represents the number of circuits. Operational temperature extended around -40°C~125°C TA. A total of 16 terminations have been recorded. A high-quality output is provided by the electrical component's 1 channels. An 5V voltage supply should allow the electrical part to be turned on and run. A total of 16 pins are injected into the electrical part body. Circuits based on SPDT switching are used to construct these analog switch ics. Search with ADG1633 if you are looking for analog multiplexer variants. In this multiplexer, the internal resistance is 4.5Ohm. The functions of 16 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 16V should not normally be supplied to the switches. Digital switch that provides Dual, Single power at a cost-effective price. The lowest voltage the electronic part should receive is 3.3V. Putting voltage greater than 600μA on the multiplexer may cause damage. For this multiplexer, dual supply voltage is feasible, but it should not exceed 8V. The voltage should be at least 3.3V if you are using dual power supplies. Operating 3 inputs is required. The data can be transferred over a wide range of bandwidths, called 109MHz bandwidths. Drain to Source resistance is 4.5Ohm. An output of 6 is provided by the digital multiplexer.