Shipping overseas is convenient with the electronic component packed in 20-SSOP (0.209, 5.30mm Width). In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. 2:1 is the ratio between multiplexers and demultiplexers. Operational temperature extended around -40°C~85°C TA. 20 terminations have been made so far. The electronic part provides high-quality output because it has 4 channels. With a 15V voltage supply, the electrical component should be turned on and run. As part of the design of the 20 series, this electronic part has been incorporated into the system. A SPDT switching circuit is used to build these analog multiplexers. Search with ADG333 if you are looking for analog multiplexer variants. A 45Ohm internal resistance characterizes this multiplexer. The functions of 20 pins can be found in the datasheets. The analogue multiplexer in this example is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 30V volts for the multiplexer. A cost-effective Dual, Single supply type analogue multiplexer. There should be 3V voltage fed to the electrical part below 3V. It would be sufficient to run this analogue multiplexer with 50nA current. Putting voltage greater than 250μA on the multiplexer may cause damage. For this switch, a dual supply voltage is feasible, but it must not exceed 20VIf you are using a dual power supply, you should attach at least 3V. 12V operating voltages can be used with this electrical part. There are 8 outputs on the analogue multiplexer.
ADG333ABRS-REEL Features
4 Channels Switch Circuit: SPDT 50nA Supply Current
ADG333ABRS-REEL Applications
There are a lot of Analog Devices Inc. ADG333ABRS-REEL Analog Switches & Multiplexers ICs applications.