The electronic component is convenient to ship overseas because it is packed in a 16-SOIC (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). In Surface Mount, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around -40°C~85°C TA. In total, 16 terminations have occurred. A electrical component with 4 channels is capable of high-quality output. Powered by a 15V voltage supply, the electrical part should be switched on and run. An electrical component of this type can be found in the 16 series. A SPST - NC switching circuit is used for these analog switches. Try searching with ADG431 to find analog multiplexer variants. Internally, this switch multiplexer has a resistance of 24Ohm. You can find the functions of the 16 pins in the datasheets. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 25V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. There should be 5V voltage fed to the electrical part below 5V. In order to operate this switch device, it would need a current of 100pA. A digital multiplexer may suffer damage if voltage is applied above 100nA. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 22V. With dual power supplies, you should attach at least 13.5V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. There is a voltage range of 12V operating voltages for the electrical part. This electronic part has additional features, such as: ALSO OPERATE WITH 12V NOMINAL SINGLE SUPPLY.
ADG431BR-REEL Features
4 Channels Switch Circuit: SPST - NC 100pA Supply Current Additional Features: ALSO OPERATE WITH 12V NOMINAL SINGLE SUPPLY
ADG431BR-REEL Applications
There are a lot of Analog Devices Inc. ADG431BR-REEL Analog Switches & Multiplexers ICs applications.