As the electronic part is packed in 16-TSSOP (0.173, 4.40mm Width), international shipping is convenient. The advanced packaging method Tube provides high reliability. Multiplexers like this are mounted in the Surface Mount position. There is 1:1 ratio between the number of multiplexers and demultiplexers. Extended operating temperature around -40°C~105°C TA. There are 16 terminations totally. By its 1 channels, the electronic component provides high-quality output. In the case of a voltage supply of 5V volts, the electrical part can be powered up and run. There are 16 pins injected into the electronic part body. These analog multiplexers are built based on SPST - NO/NC switching circuits. Try searching with ADG4613 if you're looking for variants. An switch multiplexer with 6.1Ohm internal resistance has a value of 6.1Ohm. For functions related to 16 pins, please refer to the datasheets. This switch device is a typical Multiplexer or Switches. A voltage higher than 12V should not normally be supplied to the switches. Analogue multiplexer with a Dual, Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 3V. The analogue multiplexer may be damaged if voltage is greater than 140μA. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 5.5V. A dual power supply should have at least 3V voltage attached. This analog switch ic utilizes SEPARATE OUTPUT output. Operating 4 inputs is required. The transfer of data can be performed over 250MHz bandwidths.