ADG5412BFBRUZ-RL7 Overview

The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). To ensure high reliability, a new packaging method Tape & Reel (TR) is used. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have a ratio of 1:1. Operation at a temperature around -40°C~125°C TA. The total number of terminations is 16. The electronic part delivers high-quality output through its 1 channels. If the voltage supply is 15V volts, the electrical component should be turned on and run. An electrical component of this type can be found in the 16 series. Unlike digital switches, these are based on SPST - NO switching circuits. The multiplexer consists of 4 circuits. Try searching for the analog switch ic with ADG5412 if you are looking for variants. The internal resistance of this digital multiplexer is 11.5Ohm. To find out what the 16 pins do, please refer to the datasheets. In normalcircumstances, users should not exceed 40V volts for the multiplexer. An effective Dual, Single supply digital multiplexer. 9V should be the lowest voltage fed to the electronic component. A voltage higher than 55μA may cause damage to the switch multiplexer. If put voltage greater than 22V on the multiplexer, damage may be caused to the device. It is recommended that you attach at least 9V to your dual power supply. A 160MHz-bandwidth can be used for data transfer.

ADG5412BFBRUZ-RL7 Features

1 Channels
Switch Circuit: SPST - NO
-3db Bandwidth: 270MHz
Bandwidth: 160MHz

ADG5412BFBRUZ-RL7 Applications

There are a lot of Analog Devices Inc. ADG5412BFBRUZ-RL7 Analog Switches & Multiplexers ICs applications.

• PDH Multiplexers
• Digital Cross-Connects
• Battery Powered Systems
• E1 Network Equipment
• Remote Powered Equipment
• Battery-powered systems
• Sample hold systems
• Medical systems
• Remote wireless modules
• DVD-R