ADG611YRUZ Overview

The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~125°C TA extended. In total, 16 terminations have occurred. A electrical component with 4 channels is capable of high-quality output. When the electronic component is given a voltage of 5V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NC switching circuits. Look for analog switch ic variants by searching with ADG611. A 115Ohm internal resistance characterizes this multiplexer. The datasheets for the 16 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended to use 2.7V as the lowest voltage for the electrical part. The analogue multiplexer could operate on 1nA current. A voltage higher than 1μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 5.5VFor dual power supplies, a voltage of at least 2.7V should be attached. It is possible to transfer data over a 680MHz-bandwidth. There is 85Ohm Drain to Source resistance on this electronic part.

ADG611YRUZ Features

4 Channels
Switch Circuit: SPST - NC
1nA Supply Current
Bandwidth: 680MHz
Drain-to-Source resistance: 85Ohm

ADG611YRUZ Applications

There are a lot of Analog Devices Inc.
ADG611YRUZ Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)