The electronic component is convenient to ship overseas because it is packed in a 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. 2:1 is the ratio of multiplexer to demultiplexer circuits. Operating temperature extended to -40°C~85°C TA. The total number of terminations is 8. The electronic part provides high-quality output because it has 1 channels. When the electronic component is given a voltage of 5V, it should be turned on and run. The electronic part body is injected with 8 pins. A SPDT switching circuit is used to build these analog multiplexers. If you are looking for variants of the digital switch, trying search with ADG619. The internal resistance of this digital multiplexer is 6.5Ohm. Datasheets for 8 pin functions are available upon request. In this analog multiplexer, the value is Multiplexer or Switches. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. A analog switch ic that has a cost-effective Dual, Single supply type. It is recommended that the electrical component receives a voltage of 2.7V. An operating current of 1nA would be sufficient for this switch device. Putting voltage greater than 1μA on the multiplexer may cause damage. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 5.5V. If you are using dual power supplies, you should attach at least 2.7V. There are various bandwidths available for data transfer. 2 outputs are included in the analogue multiplexer.
ADG619BRMZ-REEL Features
1 Channels Switch Circuit: SPDT 1nA Supply Current Bandwidth: 190MHz
ADG619BRMZ-REEL Applications
There are a lot of Analog Devices Inc. ADG619BRMZ-REEL Analog Switches & Multiplexers ICs applications.
Voice over IP/DSL – Integrated Access Devices, Smart