The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. The multiplexer is located in Surface Mount. 1:1 is the ratio of multiplexer to demultiplexer circuits. Increasing operating temperature to around -40°C~85°C TA. There are 8 terminations totally. As a result of its 2 channels, this electronic component provides high-quality output. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. As part of the design of the 8 series, this electronic part has been incorporated into the system. Based on SPST - NO switching circuits, these analog multiplexers work. Try searching with ADG721 to find analog multiplexer variants. In this multiplexer, the internal resistance is 4Ohm. You can find the functions of the 8 pins in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Users should never supply a voltage higher than 5.5V to a switch device. Analogue multiplexers of the Single supply type that are cost-effective. There should be 1.8V voltage fed to the electrical part below 1.8V. This digital switch can be operated with a current of 1nA. Draining from a single voltage supply, this analog switch requires a voltage of 1.8V~5.5V. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. In 200MHz-bandwidths, data can be transferred. Don't miss this electronic component's additional features, such as: ALSO OPEARTES AT 5 V SUPPLY.
ADG721BRMZ-REEL Features
2 Channels Switch Circuit: SPST - NO 1nA Supply Current Bandwidth: 200MHz Additional Features: ALSO OPEARTES AT 5 V SUPPLY
ADG721BRMZ-REEL Applications
There are a lot of Analog Devices Inc. ADG721BRMZ-REEL Analog Switches & Multiplexers ICs applications.