The electrical component comes in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around -40°C~85°C TA extended. In total, 8 terminations have occurred. A electrical component with 2 channels is capable of high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. Into the electrical component body are injected 8 pins. On the other hand, analog switches can be constructed using SPST - NO/NC switching circuits. Look for analog switch ic variants by searching with ADG723. A 4Ohm internal resistance characterizes this multiplexer. The datasheets for the 8 pins explain the functions. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. It is recommended to use 1.8V as the lowest voltage for the electrical part. Analogue multiplexers require a 1.8V~5.5V voltage to drain from a single voltage supply. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to transfer data over a 200MHz-bandwidth. You shouldn't miss the additional features of the electrical component, such as: ALSO OPEARTES AT 5 V SUPPLY.
ADG723BRM Features
2 Channels Switch Circuit: SPST - NO/NC Bandwidth: 200MHz Additional Features: ALSO OPEARTES AT 5 V SUPPLY
ADG723BRM Applications
There are a lot of Analog Devices Inc. ADG723BRM Analog Switches & Multiplexers ICs applications.
Audio and video switching
Automatic test equipment
Precision data acquisition
Battery-powered systems
Sample-and-hold systems
Communication systems
Data Acquisition Systems
Relay Replacement
Battery Powered Systems
Existing multiplexer applications (both fault-protected and nonfault-protected)