MAX4616CUD+T Overview

As the electronic part is packed in 14-TSSOP (0.173, 4.40mm Width), international shipping is convenient. A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature extended to 0°C~70°C TA. Total terminations are 14. The electronic part provides high-quality output because it has 1 channels. Powered by a 3.3V voltage supply, the electrical part should be switched on and run. The electrical component body receives 14 pins. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. There are 4 circuits in this switch device. Try searching with MAX4616 to find analog multiplexer variants. An switch multiplexer with 10Ohm internal resistance has a value of 10Ohm. Datasheets for 14 pin functions are available upon request. The analogue multiplexer in this example is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. The lowest voltage the electronic part should receive is 2V. An operating current of 1μA would be sufficient for this switch device. Using a single voltage supply, this switch device consumes 2V~5.5V volts. When the digital multiplexer is charged above 1nA, damage can occur. SEPARATE OUTPUT outputs are utilized by this digital multiplexer. Don't forget the additional features of this electronic part, such as: CAN ALSO OPERATE WITH 5 V SUPPLY.

MAX4616CUD+T Features

1 Channels
Switch Circuit: SPST - NO/NC
1μA Supply Current
-3db Bandwidth: 70MHz
Additional Features: CAN ALSO OPERATE WITH 5 V SUPPLY

MAX4616CUD+T Applications

There are a lot of Maxim Integrated
MAX4616CUD+T Analog Switches & Multiplexers ICs applications.

• Imaging
• Ultrasound
• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement