ADG723BRM-REEL7 Overview

Shipping overseas is convenient due to the electrical component's packing in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. Multiplexers like this are mounted in the Surface Mount position. Multiplexers and demultiplexers have a number of circuits 1:1. Operational temperature extended around -40°C~85°C TA. 8 terminations have been made so far. Due to its 2 channels, the electrical component produces high-quality output. When a voltage supply of 3V is used, the electronic component should be turned on and run. It is injected into the electrical part body with 8 pins. Multiplexers built on a SPST - NO/NC switching circuit are built. Try searching for the analog switch ic with ADG723 if you are looking for variants. As far as internal resistance is concerned, it has 4Ohm. To find out what the functions of 8 pins are, please refer to their datasheets. In this analog multiplexer, the value is Multiplexer or Switches. Users shouldn't supply more than 5.5V voltage to the switch device. An effective Single supply digital multiplexer. It is recommended that the electrical component receives a voltage of 1.8V. This digital switch can be operated with a current of 1nA. This analogue multiplexer requires a voltage of 1.8V~5.5V when it drains from a single voltage supply. Put voltage above 1μA on the multiplexer to cause damage. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. 200MHz-bandwidths can be used to transfer data between multiplexers. Check out the electrical component's additional features, such as the following: ALSO OPEARTES AT 5 V SUPPLY.

ADG723BRM-REEL7 Features

2 Channels
Switch Circuit: SPST - NO/NC
1nA Supply Current
Bandwidth: 200MHz
Additional Features: ALSO OPEARTES AT 5 V SUPPLY

ADG723BRM-REEL7 Applications

There are a lot of Analog Devices Inc.
ADG723BRM-REEL7 Analog Switches & Multiplexers ICs applications.

• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• New designs requiring multiplexer functions