Presented in 20-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 2:1. Increasing operating temperature to around -40°C~85°C TA. Totally, there are 20 terminations. As a result of its 4 channels, this electronic component provides high-quality output. In the case of a voltage supply of 2.5V volts, the electrical part can be powered up and run. It is injected into the electrical part body with 20 pins. A SPDT switching circuit is used for these analog switches. Try searching with ADG734 if you're looking for variants. This digital multiplexer has 4.5Ohm internal resistance. For functions related to 20 pins, please refer to the datasheets. It is a typical Multiplexer or Switches analog multiplexer. An abnormal situation would be for the switch device to be supplied with a voltage greater than 5.5V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. A low voltage of 1.8V should be applied to the electronic component. The switch device would be able to operate with 1nA current. A digital multiplexer may suffer damage if voltage is applied above 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 2.75V. It is recommended that you attach at least 2.25V to your dual power supply. In 160MHz-bandwidths, data can be transferred. In this digital multiplexer, there are 8 outputs.