NLAS2750MUTAG Overview

As the electronic part is packed in 10-UFQFN, international shipping is convenient. High reliability is provided by advanced packaging method Tape & Reel (TR). A switch device like this is mounted in Surface Mount. 2:1 is the number of circuits in the multiplexer and demultiplexer. Temperatures around -40°C~85°C TA are extended for operation. 10 terminations have been made so far. A 2.7V voltage supply should turn on and run the electronic component. A total of 10 pins are injected into the electrical part body. Circuits based on SPDT switching are used to construct these analog switch ics. 2 circuits are used in this analogue multiplexer. Analog switches have 1.3Ohm internal resistance. To find out what the 10 pins do, please refer to the datasheets. There is Multiplexer or Switches analog multiplexer like this in the world. A voltage higher than 5V should not normally be supplied to the switches. Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 1.8V. An analogue multiplexer drains from a single voltage supply at 1.8V~5V. A voltage higher than 250nA may cause damage to the switch multiplexer. SEPARATE OUTPUT outputs are utilized by this digital multiplexer.

NLAS2750MUTAG Features

Switch Circuit: SPDT
-3db Bandwidth: 44MHz

NLAS2750MUTAG Applications

There are a lot of ON Semiconductor NLAS2750MUTAG Analog Switches & Multiplexers ICs applications.

• Remote Powered Equipment
• Remote wireless modules
• DSUs
• Audio and video routing
• DSLAMs
• PDH Multiplexers
• Avionics test equipment
• Voice over IP/DSL – Integrated Access Devices, Smart
• 65 V DACs
• Relay replacements