DG300ACWE Overview

The electrical component comes in 16-SOIC (0.295, 7.50mm Width) packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tube is used. In Surface Mount, you'll find this switch device. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Operating temperature around 0°C~70°C TA extended. In total, 16 terminations have occurred. A electrical component with 1 channels is capable of high-quality output. When the electronic component is given a voltage of 15V, it should be turned on and run. Into the electrical component body are injected 16 pins. On the other hand, analog switches can be constructed using SPST - NO switching circuits. Circuits number 2 make up this analogue multiplexer. Look for analog switch ic variants by searching with DG300A. A 50Ohm internal resistance characterizes this multiplexer. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 25V. A analog switch ic that has a cost-effective Dual, Single supply type. The analogue multiplexer could operate on 230μA current. A voltage higher than 500μA may cause damage to the switch multiplexer. For this switch, a dual supply voltage is feasible, but it must not exceed 18VFor dual power supplies, a voltage of at least 5V should be attached. It is possible to use SEPARATE OUTPUT outputs on this digital multiplexer. This electrical part is compatible with 15V operating voltages.

DG300ACWE Features

1 Channels
Switch Circuit: SPST - NO
230μA Supply Current

DG300ACWE Applications

There are a lot of Maxim Integrated
DG300ACWE Analog Switches & Multiplexers ICs applications.

• Audio and video switching
• Automatic test equipment
• Precision data acquisition
• Battery-powered systems
• Sample-and-hold systems
• Communication systems
• Data Acquisition Systems
• Relay Replacement
• Battery Powered Systems
• Existing multiplexer applications (both fault-protected and nonfault-protected)