DG445CJ+ Overview

Due to its 16-DIP (0.300, 7.62mm) packaging, the electronic part is convenient for international shipping. The advanced packaging method Tube provides high reliability. A switch device like this is mounted in Through Hole. Multiplexers and demultiplexers have a number of circuits 1:1. The operating temperature is extended to around 0°C~70°C TA. In total, there are 16 terminations. By its 1 channels, the electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 10V voltage supply. This electrical component is included in the 16 series of products. Circuits based on SPST - NO switching are used to construct these analog switch ics. A 4 circuit is present in this switch device. If you are looking for variants of the digital switch, trying search with DG445. The internal resistance of this digital multiplexer is 85Ohm. Datasheets for functions of 16 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. An abnormal situation would be for the switch device to be supplied with a voltage greater than 20V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. 4.5V is the lowest voltage that should be fed to the electronic electronic part. A voltage higher than 1μA may cause damage to the switch multiplexer. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 20V. If you are using dual power supplies, you should attach at least 4.5V. In this switch multiplexer, there are SEPARATE OUTPUT outputs available.

DG445CJ+ Features

1 Channels
Switch Circuit: SPST - NO

DG445CJ+ Applications

There are a lot of Maxim Integrated DG445CJ+ Analog Switches & Multiplexers ICs applications.

• Battery Powered Instruments
• Residential Gateways, Home Gateway/Router
• Isolation
• Channel Banks
• DSUs
• Fault Tolerant Systems
• Microprocessor controlled systems
• CSU
• Avionics
• Microwave transmission systems