MAX313FESE+ Overview

Due to its 16-SOIC (0.154, 3.90mm Width) packaging, the electronic part is convenient for international shipping. This packaging method provides high reliability because it uses advanced packaging techniques. The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have a ratio of 1:1. Extended operating temperature around -40°C~85°C TA. There are 16 terminations totally. This electronic part offers high-quality output due to its 1 channels. When a voltage supply of 15V is used, the electronic component should be turned on and run. Into the electrical component body are injected 16 pins. Multiplexers built on a SPST - NO switching circuit are built. A 4 circuit is present in this switch device. Try searching for the analog switch ic with MAX313 if you are looking for variants. There is 10Ohm internal resistance in this digital multiplexer. Datasheets for 16 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 36V. A analog switch ic that has a cost-effective Dual, Single supply type. The lowest voltage fed to the electronic component should be 9V. If you put voltage higher than 100pA on the digital multiplexer, damage may occur. It is possible to supply this switch device with dual voltages. However, it is not advisable to exceed 20V. It is recommended that you attach at least 4.5V to your dual power supply. A total of SEPARATE OUTPUT outputs are available on this analog switch ic. It can operate from 20V operating voltages.

MAX313FESE+ Features

1 Channels
Switch Circuit: SPST - NO

MAX313FESE+ Applications

There are a lot of Maxim Integrated MAX313FESE+ Analog Switches & Multiplexers ICs applications.

• Industrial control systems
• Digital cross connects (DSX-1)
• Private Branch Exchange (PBX)
• Residential Gateways, Home Gateway/Router
• Cell phones
• DVD-R
• Medical Instrumentation
• Battery Powered Instruments
• Ultrasound
• ISDN NT1/TA