Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). This packaging method provides high reliability because it uses advanced packaging techniques. In Surface Mount, you'll find this switch device. 1:1 is the ratio between multiplexers and demultiplexers. Increasing operating temperature to around 0°C~70°C TA. Total terminations are 16. This electronic part offers high-quality output due to its 1 channels. Powered by a 15V voltage supply, the electrical part should be switched on and run. It is part of the design of the 16 series that this electronic component is included. Circuits based on SPST - NO/NC switching are used to construct these analog switch ics. It consists of 4 circuits. MAX314 can be used to search for analog multiplexer variants. Internally, this switch multiplexer has a resistance of 10Ohm. Datasheets for functions of 16 pins are available. There is a standard Multiplexer or Switches analogue multiplexer here. Users shouldn't supply more than 30V voltage to the switch device. Analog switch ics with Dual, Single supply type are cost-effective. It is recommended to use 4.5V as the lowest voltage for the electrical part. It may damage the digital multiplexer if the voltage is higher than 1μA. Despite this switch device's dual supply capability, its voltage should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. The electrical part can be operated at 20V voltage levels.
MAX314CUE+ Features
1 Channels Switch Circuit: SPST - NO/NC
MAX314CUE+ Applications
There are a lot of Maxim Integrated MAX314CUE+ Analog Switches & Multiplexers ICs applications.
Public switching systems
Cellular phones
PBX interfaces
Intelligent PBX
Video switching
Cable Modem
Mechanical reed relay replacement
Existing multiplexer applications (both fault-protected and nonfault-protected)