MAX4521CEE+T Overview

The electronic part can be shipped overseas conveniently because it is packaged in 16-SSOP (0.154, 3.90mm Width). High reliability is achieved by using advanced packaging method Tape & Reel (TR). It is mounted in the position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. Extended operating temperature around 0°C~70°C TA. In total, 16 terminations have occurred. This electronic part offers high-quality output due to its 1 channels. With a 5V voltage supply, the electrical component should be turned on and run. As part of the design of the 16 series, this electronic part has been incorporated into the system. A SPST - NC switching circuit is used for these analog switches. 4 circuits are used in this analogue multiplexer. Try searching for MAX4521 variants of the analog switch ic. In this multiplexer, the internal resistance is 100Ohm. For details about the functions of 16 pins, please refer to the datasheets. There is a standard Multiplexer or Switches analogue multiplexer here. A voltage higher than 12V should not normally be supplied to the switches. An effective Dual, Single supply digital multiplexer. The lowest voltage fed to the electronic component should be 2V. In order to operate this switch device, it would need a current of 1μA. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 6V. If you are using dual power supplies, you should attach at least 2V. The digital multiplexer has SEPARATE OUTPUT outputs that can be used. This electrical part is compatible with 6V operating voltages.

MAX4521CEE+T Features

1 Channels
Switch Circuit: SPST - NC
1μA Supply Current

MAX4521CEE+T Applications

There are a lot of Maxim Integrated MAX4521CEE+T Analog Switches & Multiplexers ICs applications.

• Battery Powered Systems
• Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
• Medical Instrumentation
• Digital Cross-Connects
• Channelized and Unchannelized DS3 applications
• Switching Systems
• Sample-and-hold systems
• Intelligent PBX
• Data Acquisition Systems
• Imaging