MAX4608ESE Overview

Shipping overseas is convenient with the electronic component packed in 16-SOIC (0.154, 3.90mm Width). In order to provide high reliability, an advanced packaging method Tube is used. The multiplexer is located in Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. The operating temperature is extended to around -40°C~85°C TA. There are 16 terminations totally. As a result of its 1 channels, this electronic component provides high-quality output. When a voltage supply of 15V is used, the electronic component should be turned on and run. An injection of 16 pins is performed into the body of the electrical component. A SPST - NO switching circuit is used for these analog switches. The multiplexer consists of 2 circuits. Search with MAX4608 if you are looking for analog multiplexer variants. In this multiplexer, the internal resistance is 2.5Ohm. This switch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 20V. Dual, Single supply type digital switch with a low cost. 4.5V is the lowest voltage the electrical component should receive. Putting voltage greater than 500nA on the multiplexer may cause damage. There is no problem with using dual supply voltage, but it should not exceed 20V. In the case of dual power supplies, you should connect at least 4.5V. A total of SEPARATE OUTPUT outputs are available on this analog switch ic.

MAX4608ESE Features

1 Channels
Switch Circuit: SPST - NO

MAX4608ESE Applications

There are a lot of Maxim Integrated MAX4608ESE Analog Switches & Multiplexers ICs applications.

• Multi-Line E1 Interface Cards
• Cell phones
• Modems
• Intelligent PBX
• Cable Telephony – NIU, Set-Top Box, Home Side Box
• Switching Systems
• Precision test equipment
• ATM
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Audio/video switches