MAX4656EUA+ Overview

Shipping overseas is convenient due to the electrical component's packing in 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). Advanced packaging method Tube is used to provide high reliability. Multiplexers like this are mounted in the Surface Mount position. In the multiplexer and demultiplexer, 1:1 represents the number of circuits. Around -40°C~85°C TA is the extended operating temperature. In total, there have been 8 terminations. By its 1 channels, the electronic component provides high-quality output. A 15V voltage supply should turn on and run the electronic component. This electrical component is included in the 8 series of products. The analog switch ics are built using SPST - NO switching circuits. A 1 circuit is present in this switch device. Try searching for the analog switch ic with MAX4656 if you are looking for variants. As far as internal resistance is concerned, it has 10Ohm. The functions of 8 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Multiplexers should not be powered above 40V in normal situations. An effective Dual, Single supply digital multiplexer. 9V should be the lowest voltage fed to the electronic component. If put voltage greater than 150μA on the device, damage may be caused to the analogue multiplexer. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 20V. For dual power supplies, a voltage of at least 4.5V should be attached. There is a voltage range of 20V operating voltages for the electrical part. 210MHz bandwidths enable data to be transferred. The Drain to Source resistance of this electronic component is 10Ohm.

MAX4656EUA+ Features

1 Channels
Switch Circuit: SPST - NO
Bandwidth: 210MHz
Drain-to-Source resistance: 10Ohm

MAX4656EUA+ Applications

There are a lot of Maxim Integrated MAX4656EUA+ Analog Switches & Multiplexers ICs applications.

• Battery Powered Instruments
• Avionics test equipment
• Imaging
• T1/E1 Terminals
• Private Branch Exchange (PBX)
• SONET
• Ultrasound
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• Routers
• Relay Replacement