74ACT109 Overview
As part of the package Tray, it is embedded. It is configured with a trigger that uses POSITIVE EDGE. A total of 16 terminations have been made. It is powered from a supply voltage of 5V. A device of this type belongs to the family of ACT. This device is part of the FF/Latchesbase part number family. The design is based on 2bits. There is a 5.5Vmaximum supply voltage (Vsup). A normal operating voltage (Vsup) should remain above 4.5V. Considering the reliability of this T flip flop, it is well suited for RAIL. The system runs on a power supply of 5V watts. The logic IC it uses is J-KBAR FLIP-FLOP. A total of 2 functions are available on the T flip flop. With 16 pins, it is equipped with a low power consumption.
74ACT109 Features
Tray package
2 Bits
5V power supplies
2 Functions
16 pin count
74ACT109 Applications
There are a lot of MICROSS/On Semiconductor 74ACT109 Flip Flops applications.
- Test & Measurement
- Latch
- Frequency division
- Functionally equivalent to the MC10/100EL29
- Set-reset capability
- Guaranteed simultaneous switching noise level
- Bus hold
- Memory
- Instrumentation
- Load Control
