74ACT377MTCX Overview

The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). The Tape & Reel (TR)package contains it. It is configured with Non-Invertedas an output. It is configured with a trigger that uses a value of Positive Edge. Surface Mountmounts this electrical part. The JK flip flop operates at 4.5V~5.5Vvolts. -40°C~85°C TAis the operating temperature. This electronic flip flop is of type D-Type. FPGAs belonging to the 74ACTseries contain this type of chip. There should be no greater frequency than 175MHzon its output. There are 1 elements in it. As a result, it consumes 40μA of quiescent current without being affected by external factors. The object belongs to the 74ACT377 family. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This electronic part is mounted in the way of Surface Mount. The electronic flip flop is designed with pins 20. This device has the clock edge trigger type of Positive Edge. 8bits are used in its design. Its superior flexibility is attributed to its use of 8 circuits. In order to achieve high efficiency, the supply voltage should be maintained at 5V. There are 8 output lines in this JK flip flop. A total of 8input lines have been provided. -24mA is set as the high level output current. There is 24mA output current at the low level. Ideally, the operating temperature should be lower than 85°C. Operating temperatures should be above -40°C. The minimal supply voltage is 4.5V. 5.5Vis the maximum supply voltage it supports. The frequency can be set to 175MHz.

74ACT377MTCX Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits

74ACT377MTCX Applications

There are a lot of ON Semiconductor 74ACT377MTCX Flip Flops applications.

• Cold spare funcion
• Matched Rise and Fall
• Patented noise
• Test & Measurement
• Convert a momentary switch to a toggle switch
• ESD performance
• Bounce elimination switch
• Registers
• Frequency division
• Event Detectors