74ACTQ273SJX Overview

As a result, it is packaged as 20-SOIC (0.209, 5.30mm Width). D flip flop is included in the Tape & Reel (TR)package. In the configuration, Non-Invertedis used as the output. This trigger uses the value Positive Edge. Surface Mountmounts this electrical part. A supply voltage of 4.5V~5.5V is required for operation. A temperature of -40°C~85°C TAis considered to be the operating temperature. This D latch has the type D-Type. This type of FPGA is a part of the 74ACTQ series. Its output frequency should not exceed 189MHz Hz. A total of 1elements are present in it. During its operation, it consumes 40μA quiescent energy. The 74ACTQ273 family contains it. Its input capacitance is 4.5pFfarads. A part of the electronic system is mounted in the way of Surface Mount. It is designed with 20 pins. This device has the clock edge trigger type of Positive Edge. There are 8bits in this flip flop. Due to its superior flexibility, it uses 8 circuits. A high level of efficiency can be achieved by maintaining the supply voltage at 5V. In order to operate, the chip has 8 output lines. A total of 8input lines have been provided. It is set to -24mAfor the high level output current. It is set to 24mAfor the low level output current. Ideally, the operating temperature should be below 85°C. Operating temperatures should be above -40°C. Despite its minimal supply voltage of 4.5V, it is capable of operating. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 189MHz frequencies.

74ACTQ273SJX Features

Tape & Reel (TR) package
74ACTQ series
20 pins
8 Bits

74ACTQ273SJX Applications

There are a lot of ON Semiconductor 74ACTQ273SJX Flip Flops applications.

• Parallel data storage
• Single Down Count-Control Line
• Reduced system switching noise
• Registers
• Supports Live Insertion
• Cold spare funcion
• Balanced Propagation Delays
• Test & Measurement
• Synchronous counter
• QML qualified product