DM74AS574WMX Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). D flip flop is embedded in the Tape & Reel (TR) package. The output it is configured with uses Tri-State, Non-Inverted. There is a trigger configured with Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. A temperature of 0°C~70°C TAis used in the operation. There is D-Type type of electronic flip flop associated with this device. The FPGA belongs to the 74AS series. Its output frequency should not exceed 80MHz. A total of 1elements are present in it. There is 116mA quiescent consumption. The 74AS574 family contains it. There is an electronic component mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has the clock edge trigger type of Positive Edge. There are 8bits in this flip flop. 8 circuits are used to achieve its superior flexibility. For high efficiency, the supply voltage should be set to 5V. In order for the chip to function, it has 3output lines. 8input lines are available for you to choose from. -15mAis the output current at high level. 48mA is the low level output current. Ideally, the operating temperature should be lower than 70°C. It should be higher than 0°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. 5.5Vis the maximum supply voltage supported by it. It is possible to obtain a frequency of 80MHz.

DM74AS574WMX Features

Tape & Reel (TR) package
74AS series
20 pins
8 Bits

DM74AS574WMX Applications

There are a lot of ON Semiconductor DM74AS574WMX Flip Flops applications.

• Consumer
• Safety Clamp
• Latch
• Balanced 24 mA output drivers
• Latch-up performance
• Counters
• Frequency Dividers
• Data transfer
• Frequency Divider circuits
• ESD performance