MC100EP29MNG Overview

QFNis the way it is packaged. The package Tubecontains it. The element count is 2 . A total of 20 terminations have been made. Power is provided by a 3.3V supply. Surface Mount mounts this electronic component. 20pins are included in its design. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. This device has the base part number FF/Latches. On the basis of its reliable performance, this D flip flop is well suited for use with RAIL. The D latch operates on -4.5V volts. To operate, the chip has a total of 1 output lines. It is also characterized by NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V. There is -50mA output current at the high level. Low level output current is set to 50mA. It is recommended that the operating temperature be lower than 85°C. Temperatures above -40°Cshould be used. The system operates with a minimum supply voltage of 3V. There is a maximum voltage support of 5.5V. It is possible to achieve 3GHz frequencies. D FLIP-FLOPis used as the logic IC in this D flip flop. It is equipped with 2 Functions . This device is equipped with a pin count of 20.

MC100EP29MNG Features

Tube package
20 pins
-4.5V power supplies
2 Functions
20 pin count

MC100EP29MNG Applications

There are a lot of ON Semiconductor MC100EP29MNG Flip Flops applications.

• Set-reset capability
• Shift registers
• Guaranteed simultaneous switching noise level
• Bus hold
• ESD performance
• Data storage
• Differential Individual
• Patented noise
• Count Modes
• Dynamic threshold performance