MC100EP51DR2 Overview
The flip flop is packaged in a case of 8-SOIC (0.154, 3.90mm Width). The Tape & Reel (TR)package contains it. As configured, the output uses Differential. This trigger uses the value Positive, Negative. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates at a voltage of -3V~-5.5V. Temperature is set to -40°C~85°C TA. This logic flip flop is classified as type D-Type. FPGAs belonging to the 100EPseries contain this type of chip. Its output frequency should not exceed 3GHz Hz. As a result, it consumes 45mA quiescent current. 8terminations have occurred. This D latch belongs to the family of 100EP51. A voltage of 3.3V is used as the power supply for this D latch. The electronic part is mounted in the way of Surface Mount. 8pins are included in its design. This device's clock edge trigger type is Positive Edge. There is a base part number FF/Latchesfor the RS flip flops. There are 1bits in its design. There is a 5.5Vmaximum supply voltage (Vsup). Keeping the supply voltage (Vsup) above 3V is necessary for normal operation. Despite its superior flexibility, it relies on 1 circuits to achieve it. As a result of its reliability, this D flip flop is ideally suited for TAPE AND REEL. A power supply of -4.5Vis required to operate it. In addition, NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5Vis a characteristic of it. The high level output current is set to -50mA. The low level output current is set to 50mA.
MC100EP51DR2 Features
Tape & Reel (TR) package
100EP series
8 pins
1 Bits
-4.5V power supplies
MC100EP51DR2 Applications
There are a lot of ON Semiconductor MC100EP51DR2 Flip Flops applications.
- Buffered Clock
- CMOS Process
- Single Down Count-Control Line
- Guaranteed simultaneous switching noise level
- Frequency division
- Digital electronics systems
- Synchronous counter
- Single Up Count-Control Line
- Counters
- High Performance Logic for test systems
