MC74LCX374DWR2G Overview

The package is in the form of 20-SOIC (0.295, 7.50mm Width). As part of the package Tape & Reel (TR), it is embedded. There is a Tri-State, Non-Invertedoutput configured with it. This trigger is configured to use Positive Edge. There is an electrical part that is mounted in the way of Surface Mount. A voltage of 2V~3.6Vis required for its operation. Currently, the operating temperature is -40°C~85°C TA. The type of this D latch is D-Type. The 74LCXseries comprises this type of FPGA. Its output frequency should not exceed 150MHz. In total, there are 1 elements. T flip flop consumes 10μA quiescent energy. There are 20 terminations,It is a member of the 74LCX16374 family. Power is supplied from a voltage of 3.3V volts. A JK flip flop with a 7pFfarad input capacitance is used here. It is a member of the LVC/LCX/Zfamily of D flip flop. Electronic part Surface Mountis mounted in the way. 20pins are included in its design. This device has Positive Edgeas its clock edge trigger type. The part is included in FF/Latches. There are 8bits in its design. Normal operation requires a supply voltage (Vsup) above 2V. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. There are 2 terminations, which are the practice of ending a transmission line with a device that matches the characteristic impedance of the line. If high efficiency is to be achieved, the supply voltage should be maintained at 3.3V. It operates with 3 output lines. There are 8 channels available.

MC74LCX374DWR2G Features

Tape & Reel (TR) package
74LCX series
20 pins
8 Bits

MC74LCX374DWR2G Applications

There are a lot of ON Semiconductor MC74LCX374DWR2G Flip Flops applications.

• Reduced system switching noise
• Balanced Propagation Delays
• Matched Rise and Fall
• Asynchronous counter
• Power down protection
• Test & Measurement
• Count Modes
• CMOS Process
• Pattern generators
• Latch