Due to its 16-WFQFN packaging, the electronic part is convenient for international shipping. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. Mounted in Surface Mount is this multiplexer. In the multiplexer and demultiplexer, 2:2 represents the number of circuits. Extended operating temperature around -40°C~85°C TA. The total number of terminations is 16. A electrical component with 2 channels is capable of high-quality output. In the case of a voltage supply of 3V volts, the electrical part can be powered up and run. The electrical component body receives 16 pins. Multiplexers built on a DPDT switching circuit are built. There are 2 circuits in this multiplexer. Search with NLAS3899B if you are looking for analog multiplexer variants. There is 2.5Ohm internal resistance in this digital multiplexer. The functions of 16 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 4.3V. A analog switch ic that has a cost-effective Single supply type. A low voltage of 1.65V should be applied to the electronic component. For this digital switch to work, 1μA current would suffice. The voltage required by this switch device is 1.65V~4.3V, draining from a single voltage supply. Putting voltage greater than 2μA on the multiplexer may cause damage. Operating voltages of 3V are compatible with the electrical part. Operating 4 inputs is required. A analog switch ics with 8 outputs is included.