Presented in 16-TSSOP (0.173, 4.40mm Width), this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 2:1. Operational temperature extended around -55°C~125°C TA. In total, there are 16 terminations. By its 2 channels, the electronic component provides high-quality output. When the electronic component is given a voltage of 3V, it should be turned on and run. It is part of the design of the 16 series that this electronic component is included. The analog switch ics are built using SPDT switching circuits. This multiplexer is composed of 3 circuits. Try searching with NLAS4053 to find analog multiplexer variants. Analog switches have 33Ohm internal resistance. For functions related to 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 5.5V. Dual, Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 2.5V. The analogue multiplexer could operate on 40μA current. Dual supply volatge is feasible for this multiplexer. But it should not go beyond 3.3V. With dual power supplies, you should attach at least 1.25V. There is an analog IC SINGLE-ENDED MULTIPLEXER integrated with this board. A 6 input needs to be operated. There are various bandwidths available for data transfer.