NLAS5113DFT2G Overview

The electrical component comes in 6-TSSOP, SC-88, SOT-363 packaging, which makes it convenient to ship overseas. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 1:1. Temperatures around -40°C~85°C TA are extended for operation. 6 terminations have been made so far. High-quality output is provided by the electronic component's 1 channels. When a voltage supply of 4.2V is used, the electronic component should be turned on and run. A key feature of the 6 series is the inclusion of this electronic part as part of its design. Unlike digital switches, these are based on SPST - NO switching circuits. Try searching for the analog switch ic with NLAS5113 if you are looking for variants. Internally, this switch multiplexer has a resistance of 1.3Ohm. Datasheets for 6 pin functions are available upon request. A analogue multiplexer of this type is a Multiplexer or Switches. Multiplexers should not be powered above 4.5V in normal situations. Single supply type digital switch with a low cost. It is recommended to use 1.65V as the lowest voltage for the electrical part. It would be sufficient to run this analogue multiplexer with 1μA current. This analog switch requires a voltage of 1.65V~4.5V to drain from a single voltage supply. The electronic component can function from 3V. Operating the 1 inputs requires 1 inputs.

NLAS5113DFT2G Features

1 Channels
Switch Circuit: SPST - NO
1μA Supply Current
-3db Bandwidth: 457MHz

NLAS5113DFT2G Applications

There are a lot of ON Semiconductor NLAS5113DFT2G Analog Switches & Multiplexers ICs applications.

• PDH Multiplexers
• PBXs
• Imaging
• Video switching
• Battery-powered systems
• SONET
• Remote wireless modules
• Cell phones
• Existing multiplexer applications (both fault-protected and nonfault-protected)
• ATM