The electronic component is convenient to ship overseas because it is packed in a 16-TSSOP (0.173, 4.40mm Width). This high-reliability packaging method uses advanced packaging methods Tape & Reel (TR). The multiplexer is located in Surface Mount. In the multiplexer and demultiplexer, 2:2 represents the number of circuits. The operating temperature is extended to around -55°C~125°C TA. In total, there have been 16 terminations. As a result of its 2 channels, this electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 2.5V voltage supply. Into the electrical component body are injected 16 pins. Multiplexers built on a DPDT switching circuit are built. Try searching with NLAST44599 to find analog multiplexer variants. An switch multiplexer with 30Ohm internal resistance has a value of 30Ohm. For functions related to 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. The lowest voltage fed to the electronic component should be 2V. This multiplexer would work with 4μA current. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. It may damage the digital multiplexer if the voltage is higher than 4μA. A 4 input needs to be operated. The analog switch ics includes 8 outputs.