Shipping overseas is convenient with the electronic component packed in 16-TSSOP (0.173, 4.40mm Width). The advanced packaging method Tape & Reel (TR) provides high reliability. Surface Mount is where this multiplexer is located. 2:1 is the number of circuits in the multiplexer and demultiplexer. An extended operating temperature of -55°C~125°C TA degrees Celsius. 16 terminations have been made so far. High-quality output is provided by the electronic component's 1 channels. In the case of a voltage supply of 4.5V volts, the electrical part can be powered up and run. It is part of the design of the 16 series that this electronic component is included. Based on SPDT switching circuits, these analog multiplexers work. Using the M74HC43 search parameter, you can discover variants of the switch. The internal resistance of this digital multiplexer is 70Ohm. Please refer to the datasheets for 16 pins functions. The analogue multiplexer in this example is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 12V. Analogue multiplexer with a Dual, Single supply type that is cost-effective. In order for the electronic part to function properly, the lowest voltage should be 2V. 1μA current would be enough for this multiplexer to operate. The switch multiplexer may be damaged if it is exposed to voltage greater than 1μA. There's no problem with dual supply voltage for this switch device. However, it shouldn't exceed 6V. The voltage should be at least 1V if you are using dual power supplies. This analog switch ic utilizes SEPARATE OUTPUT output. The 4 inputs need to be operated in order to work.