M74HC574TTR Overview

The package is in the form of 20-TSSOP (0.173, 4.40mm Width). Package Cut Tape (CT)embeds it. Tri-State, Non-Invertedis the output configured for it. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis positioned in the way of this electronic part. A voltage of 2V~6Vis used as the supply voltage. It is operating at a temperature of -55°C~125°C TA. A flip flop of this type is classified as a D-Type. FPGAs belonging to the 74HCseries contain this type of chip. You should not exceed 90MHzin its output frequency. The list contains 1 elements. There is a consumption of 4μAof quiescent energy. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The M74HC57 family contains it. The power source is powered by 4.5V. A JK flip flop with a 5pFfarad input capacitance is used here. This D flip flop belongs to the family of HC/UH. It is mounted in the way of Surface Mount. It is designed with 20 pins. A Positive Edgeclock edge trigger is used in this device. This RS flip flops is a part number FF/Latches. The design is based on 8bits. Vsup reaches 6V, the maximal supply voltage. Normally, the supply voltage (Vsup) should be kept above 2V. To achieve this superior flexibility, 8 circuits are used. In light of its reliable performance, this T flip flop is well suited for TAPE AND REEL. There are 2/6V power supplies attached to it. A D flip flop with 2embedded ports is available. There are 3 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code.

M74HC574TTR Features

Cut Tape (CT) package
74HC series
20 pins
8 Bits
2/6V power supplies

M74HC574TTR Applications

There are a lot of STMicroelectronics M74HC574TTR Flip Flops applications.

• Power down protection
• 2 – Bit synchronous counter
• Frequency Dividers
• Latch
• Safety Clamp
• Instrumentation
• Divide a clock signal by 2 or 4
• Frequency Divider circuits
• Computers
• Bus hold