74FCT16374ATPVCG4 Overview
The flip flop is packaged in a case of SSOP. D latch consists of 2 elements. Terminations are 48. The power source is powered by 5V. Electronic devices of this type belong to the FCTfamily. Electronic part Surface Mountis mounted in the way. With its 48pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. The design is based on 16bits. Its flexibility is enhanced by 1 circuits. Due to its reliability, this T flip flop is well suited for TUBE. The D latch runs on a voltage of 5V volts. The D flip flop has no ports embedded. In order to ensure high efficiency, the supply voltage should remain at 5V. To operate, the chip has a total of 3 output lines. This input has 8lines in it. This D latch consumes 5μA quiescent current at all. It is set to -32mAfor the high level output current. It is set to 64mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 4.5VV as its minimum supply voltage. It supports a maximum supply voltage of 5.5V volts. In this case, it uses a BUS DRIVER logic IC. It is equipped with 2 functions . The D latch is equipped with 48 pins. As a result of its output current of 64mA, it is very flexible in terms of design.
74FCT16374ATPVCG4 Features
48 pins
16 Bits
5V power supplies
2 Functions
48 pin count
74FCT16374ATPVCG4 Applications
There are a lot of Texas Instruments
74FCT16374ATPVCG4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
