CD74HC74M96E4 Overview
The flip flop is packaged in SOIC. Package Tape & Reel (TR)embeds it. In total, there are 2 elements. Currently, there are 14 terminations. The D flip flop is powered by a voltage of 4.5V . Devices in the HC/UHfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 14pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchfor the RS flip flops. An electronic part designed with 1bits is used in this application. As a result of its reliable performance, this T flip flop is suitable for TR. As of now, there are 1input lines. In terms of quiescent current, it consumes 4μA . -5.2mA is set as the high level output current. In the low level output current setting, 5.2mAis used. It is recommended that the operating temperature be below 125°C. Ideally, the operating temperature should be higher than -55°C. A minimum supply voltage of 2V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 6V. It is possible to achieve 50MHz frequencies. It uses a logic IC with a D FLIP-FLOP value. A total of 2 functions are available on the T flip flop. There are 14 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 5.2mA.
CD74HC74M96E4 Features
Tape & Reel (TR) package
14 pins
1 Bits
2 Functions
14 pin count
CD74HC74M96E4 Applications
There are a lot of Texas Instruments
CD74HC74M96E4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
