The electrical component comes in 16-DIP (0.300, 7.62mm) packaging, which makes it convenient to ship overseas. Advanced packaging method Tube is used to provide high reliability. Multiplexers like this are mounted in the Through Hole position. Multiplexers and demultiplexers have the same number of circuits 4:1. The operating temperature is extended to around -55°C~125°C TA. In total, 16 terminations have occurred. This electronic part offers high-quality output due to its 2 channels. With a 4.5V voltage supply, the electrical component should be turned on and run. The electronic part body is injected with 16 pins. Based on SP4T switching circuits, these analog multiplexers work. There are 2 circuits in this switch device. Use 74HCT4052 to search for variants of the digital switches. This digital multiplexer has 130Ohm internal resistance. The functions of 16 pins can be found in the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 5.5V volts for the multiplexer. Analogue multiplexers of the Dual, Single supply type that are cost-effective. A low voltage of 4.5V should be applied to the electronic component. For this switch device, it is feasible to have two supplies. However, the voltage should not exceed 5V. A dual power supply should have at least 1V voltage attached. A DIFFERENTIAL MULTIPLEXER analog IC is integrated into the board. The electrical part can be operated at 5V voltage levels. The electrical component supports 8 inputs. There are 185MHz bandwidths for data transfer. 4-bit conductivity is possible.