CY74FCT2574ATQCT Overview

The flip flop is packaged in 20-SSOP (0.154, 3.90mm Width). D flip flop is included in the Cut Tape (CT)package. Tri-State, Non-Invertedis the output configured for it. The trigger configured with it uses Positive Edge. There is an electric part mounted in the way of Surface Mount. The JK flip flop operates at 4.75V~5.25Vvolts. -40°C~85°C TAis the operating temperature. The type of this D latch is D-Type. In this case, it is a type of FPGA belonging to the 74FCT series. In total, there are 1 elements. As a result, it consumes 200μA quiescent current and is not affected by external forces. Currently, there are 20 terminations. It is a member of the 74FCT2574 family. The power source is powered by 5V. This JK flip flop has a 5pFfarad input capacitance. The electronic device belongs to the FCTfamily. It is mounted in the way of Surface Mount. It is designed with 20 pins. In this device, the clock edge trigger type is Positive Edge. There is a FF/Latchesbase part number assigned to the RS flip flops. An electronic part with 8bits has been designed. Its superior flexibility is attributed to its use of 8 circuits. Considering its reliability, this T flip flop is well suited for TR. It operates from 5V power supplies. The flip flop has 2embedded ports. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. The output current of 12mA makes it feature maximum design flexibility. To operate, the chip has a total of 3 output lines. It is possible to achieve a frequency of 250MHz.

CY74FCT2574ATQCT Features

Cut Tape (CT) package
74FCT series
20 pins
8 Bits
5V power supplies

CY74FCT2574ATQCT Applications

There are a lot of Texas Instruments CY74FCT2574ATQCT Flip Flops applications.

• Load Control
• Functionally equivalent to the MC10/100EL29
• Latch-up performance
• Bus hold
• Computing
• Frequency Dividers
• Patented noise
• Common Clocks
• Safety Clamp
• Bounce elimination switch