CY74FCT2574TSOC Overview
It is embeded in 20-SOIC (0.295, 7.50mm Width) case. It is contained within the Tubepackage. There is a Tri-State, Non-Invertedoutput configured with it. JK flip flop uses Positive Edgeas the trigger. Surface Mountis in the way of this electric part. It operates with a supply voltage of 4.75V~5.25V. It is operating at -40°C~85°C TA. This electronic flip flop is of type D-Type. The FPGA belongs to the 74FCT series. Its output frequency should not exceed 250MHz Hz. D latch consists of 1 elements. This process consumes 200μA quiescents. There are 20 terminations,It is a member of the 74FCT2574 family. It is powered from a supply voltage of 5V. This JK flip flop has a 5pFfarad input capacitance. A device of this type belongs to the family of FCT. Electronic part Surface Mountis mounted in the way. A total of 20pins are provided on this board. Its clock edge trigger type is Positive Edge. It is included in FF/Latches. The design is based on 8bits. 5.25Vis the maximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be kept above 4.75V. 8 circuits are used to achieve its superior flexibility. It runs on 5Vvolts of power. The D flip flop has no ports embedded. There are 3 output Lines, which generate the binary equivalent of the input line whose value is equal to “1” and are available to encode either a decimal or hexadecimal input pattern to typically a binary or “B. C. D” (binary coded decimal) output code.
CY74FCT2574TSOC Features
Tube package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT2574TSOC Applications
There are a lot of Texas Instruments CY74FCT2574TSOC Flip Flops applications.
- Data Synchronizers
- Set-reset capability
- CMOS Process
- Memory
- Storage registers
- 2 – Bit synchronous counter
- Consumer
- Cold spare funcion
- EMI reduction circuitry
- Matched Rise and Fall
