CY74FCT574TQCTG4 Overview
It is packaged in the way of 20-SSOP (0.154, 3.90mm Width). The package Tape & Reel (TR)contains it. T flip flop is configured with an output of Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. The electronic part is mounted in the way of Surface Mount. A 4.75V~5.25Vsupply voltage is required for it to operate. Currently, the operating temperature is -40°C~85°C TA. D-Typedescribes this flip flop. The FPGA belongs to the 74FCT series. A total of 1 elements are present. Despite external influences, it consumes 200μAof quiescent current. It has been determined that there have been 20 terminations. JK flip flop belongs to 74FCT574 family. A voltage of 5V provides power to the D latch. This JK flip flop has a 5pFfarad input capacitance. An electronic device belonging to the family FCTcan be found here. This electronic part is mounted in the way of Surface Mount. With its 20pins, it is designed to work with most electronic flip flops. This device exhibits a clock edge trigger type of Positive Edge. This part is included in FF/Latches. An electronic part with 8bits has been designed. Its superior flexibility is attributed to its use of 8 circuits. On the basis of its reliable performance, this D flip flop is well suited for use with TR. A power supply of 5Vis required to operate it. The D flip flop is embedded with 2ports. For high efficiency, the supply voltage should be set to 5V. It offers maximum design flexibility with its output current of 64mA. This frequency can be achieved 250MHz.
CY74FCT574TQCTG4 Features
Tape & Reel (TR) package
74FCT series
20 pins
8 Bits
5V power supplies
CY74FCT574TQCTG4 Applications
There are a lot of Texas Instruments CY74FCT574TQCTG4 Flip Flops applications.
- Buffered Clock
- Pattern generators
- Frequency division
- CMOS Process
- Modulo – n – counter
- Reduced system switching noise
- Asynchronous counter
- Balanced 24 mA output drivers
- Guaranteed simultaneous switching noise level
- Event Detectors
