SN74ABT574ADWRE4 Overview
The package is in the form of SOIC. As part of the package Tape & Reel (TR), it is embedded. In the configuration, TTLis used as the output. The element count is 1 . 20terminations have occurred. It is powered by a voltage of 5V . A device of this type belongs to the family of ABT. It is mounted in the way of Surface Mount. There are 20pins on it. The clock edge trigger type for this device is Positive Edge. A reliable performance of this D flip flop makes it well suited for use in TR. A power supply of 5Vis required to operate it. The flip flop contains 2ports. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop. A high level output current of -32mAis set. In the low level output current setting, the current is set to 64mA. Ideally, the operating temperature should be below 85°C. If the operating temperature is higher than -40°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. A maximum voltage of 5.5V can be provided by it. This frequency can be achieved at 200MHz. There is a logic IC BUS DRIVER used in the D flip flop. It has 1 functions. 20pins are available on this JK flip flop. With an output current of 64mA, this flip flop offers maximum design flexibility.
SN74ABT574ADWRE4 Features
Tape & Reel (TR) package
20 pins
5V power supplies
1 Functions
20 pin count
SN74ABT574ADWRE4 Applications
There are a lot of Texas Instruments
SN74ABT574ADWRE4 Flip Flops applications.
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
