SN74HC74PWRE4 Overview
The flip flop is packaged in a case of TSSOP. You can find it in the Tape & Reel (TR)package. D latch consists of 2 elements. Terminations are 14. The power source is powered by 5V. Electronic devices of this type belong to the HC/UHfamily. Electronic part Surface Mountis mounted in the way. With its 14pins, it is designed to work with most electronic flip flops. In this device, the clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. Due to its reliability, this T flip flop is well suited for TR. In order to ensure high efficiency, the supply voltage should remain at 5V. This input has 4lines in it. It is set to -5.2mAfor the high level output current. It is set to 5.2mAfor the low level output current. If the operating temperature is lower than 85°C, it is recommended. It should be higher than -40°Cwhen the system is operating. Normally, it operates with a voltage of 2VV as its minimum supply voltage. It supports a maximum supply voltage of 6V volts. This frequency can be achieved 60MHz. In this case, it uses a D FLIP-FLOP logic IC. It is equipped with 2 functions . The D latch is equipped with 14 pins. As a result of its output current of 5.2mA, it is very flexible in terms of design.
SN74HC74PWRE4 Features
Tape & Reel (TR) package
14 pins
2 Functions
14 pin count
SN74HC74PWRE4 Applications
There are a lot of Texas Instruments
SN74HC74PWRE4 Flip Flops applications.
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
- Asynchronous counter
