SN74ACT374PWG4 Overview
The flip flop is packaged in TSSOP. In total, there are 1 elements. Currently, there are 20 terminations. The D flip flop is powered by a voltage of 5V . Devices in the ACTfamily are electronic devices. A part of the electronic system is mounted in the way of Surface Mount. This board is designed with 20pins on it. This device has Positive Edgeas its clock edge trigger type. There is a base part number FF/Latchesfor the RS flip flops. As a result of its reliable performance, this T flip flop is suitable for TUBE. It runs on 5Vvolts of power. A D flip flop with 2embedded ports is available. If high efficiency is desired, the supply voltage should be kept at 5V. -24mA is set as the high level output current. In the low level output current setting, 24mAis used. It is recommended that the operating temperature be below 85°C. Ideally, the operating temperature should be higher than -40°C. A minimum supply voltage of 4.5V is required for these RS flip flops to operate. In this case, it supports a maximum supply voltage of 5.5V. It is possible to achieve 160MHz frequencies. It uses a logic IC with a BUS DRIVER value. A total of 1 functions are available on the T flip flop. There are 20 pins on the D latch. This flip flop features a maximum design flexibility due to its output current of 24mA.
SN74ACT374PWG4 Features
20 pins
5V power supplies
1 Functions
20 pin count
SN74ACT374PWG4 Applications
There are a lot of Texas Instruments
SN74ACT374PWG4 Flip Flops applications.
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
- Memory
- Event Detectors
- Data Synchronizers
