SN74LVC574ARGYRG4 Overview
In the form of VQFN, it has been packaged. A total of 1elements are contained within it. The number of terminations is 20. An input voltage of 1.8Vpowers the D latch. In this case, the D flip flop belongs to the LVC/LCX/Zfamily. There is an electronic component mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. It is designed with a number of bits of 8. Using 8 circuits, it is highly flexible. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. The flip flop has 2embedded ports. The JK flip flop is with 3 output lines to operate. The number of input lines is 2. In this case, the high level output current is set to -24mA. 24mAis set as the low level output current. There should be a temperature below 125°Cduring operation. In order for the system to operate properly, the temperature should be higher than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 1.65VV. There is a maximum voltage support of 3.6V. A frequency of 150MHzcan be achieved. BUS DRIVERis the logic IC it uses. There are 1 functions available on this T flip flop. A total of 20 pins are present on this device. Its output current of 24mA allows for maximum design flexibility.
SN74LVC574ARGYRG4 Features
20 pins
8 Bits
1 Functions
20 pin count
SN74LVC574ARGYRG4 Applications
There are a lot of Texas Instruments
SN74LVC574ARGYRG4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
