SN74ACT534PWRG4 Overview

It is embeded in 20-TSSOP (0.173, 4.40mm Width) case. The Tape & Reel (TR)package contains it. Tri-State, Invertedis the output configured for it. The trigger it is configured with uses Positive Edge. It is mounted in the way of Surface Mount. A supply voltage of 4.5V~5.5V is required for operation. In the operating environment, the temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. In terms of FPGAs, it belongs to the 74ACT series. You should not exceed 100MHzin the output frequency of the device. A total of 1elements are contained within it. There is a consumption of 4μAof quiescent energy. There have been 20 terminations. D latch belongs to the 74ACT534 family. A voltage of 5V is used to power it. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. This D flip flop belongs to the family of ACT. A part of the electronic system is mounted in the way of Surface Mount. A total of 20pins are provided on this board. Its clock edge trigger type is Positive Edge. This RS flip flops is a part number FF/Latches. An electronic part designed with 8bits is used in this application. Its flexibility is enhanced by 8 circuits. Considering the reliability of this T flip flop, it is well suited for TR. There are 5V power supplies attached to it. There are 2 ports embedded in the flip flops. Optimal efficiency requires a supply voltage of 5V. With an output current of 24mA, it is possible to design the device in any way you want.

SN74ACT534PWRG4 Features

Tape & Reel (TR) package
74ACT series
20 pins
8 Bits
5V power supplies

SN74ACT534PWRG4 Applications

There are a lot of Texas Instruments SN74ACT534PWRG4 Flip Flops applications.

• Supports Live Insertion
• Counters
• Registers
• Single Down Count-Control Line
• Buffer registers
• Bounce elimination switch
• Frequency Dividers
• Instrumentation
• Communications
• Computing