SN74ALS374ADWR Overview

The flip flop is packaged in a case of 20-SOIC (0.295, 7.50mm Width). It is contained within the Tape & Reel (TR)package. In the configuration, Tri-State, Non-Invertedis used as the output. The trigger configured with it uses Positive Edge. This electronic part is mounted in the way of Surface Mount. The JK flip flop operates with an input voltage of 4.5V~5.5V volts. The operating temperature is 0°C~70°C TA. There is D-Type type of electronic flip flop associated with this device. This type of FPGA is a part of the 74ALS series. It should not exceed 35MHzin its output frequency. The list contains 1 elements. As a result, it consumes 19mA quiescent current and is not affected by external forces. 20terminations have occurred. D latch belongs to the 74ALS374 family. A voltage of 5V is used to power it. The electronic device belongs to the ALSfamily. A part of the electronic system is mounted in the way of Surface Mount. 20pins are included in its design. This device's clock edge trigger type is Positive Edge. This device has the base part number FF/Latches. The flip flop is designed with 8bits. 8 circuits are used to achieve its superior flexibility. In light of its reliable performance, this T flip flop is well suited for TR. The D latch runs on a voltage of 5V volts. There are 2 ports embedded in the flip flops. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. With a current output of 24mA , it offers maximum design flexibility. The number of input lines is 3.

SN74ALS374ADWR Features

Tape & Reel (TR) package
74ALS series
20 pins
8 Bits
5V power supplies

SN74ALS374ADWR Applications

There are a lot of Texas Instruments SN74ALS374ADWR Flip Flops applications.

• Registers
• Patented noise
• Divide a clock signal by 2 or 4
• Safety Clamp
• Matched Rise and Fall
• Set-reset capability
• Load Control
• Automotive
• Individual Asynchronous Resets
• Dynamic threshold performance