SN74AUC2G53YZTR Overview

Packed in 8-UFBGA, DSBGA, the electronic component is convenient for shipping overseas. In order to provide high reliability, an advanced packaging method Tape & Reel (TR) is used. In Surface Mount, you'll find this switch device. 2:1 is the ratio of multiplexer to demultiplexer circuits. The operating temperature is extended to around -40°C~85°C TA. In total, there have been 8 terminations. This electronic part offers high-quality output due to its 2 channels. A 1.1V voltage supply should turn on and run the electronic component. An electrical component of this type can be found in the 8 series. Based on SPDT switching circuits, these analog multiplexers work. It consists of 1 circuits. Search with 74AUC2G53 if you are looking for analog multiplexer variants. A 15Ohm internal resistance characterizes this multiplexer. To find out what the 8 pins do, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. Multiplexers should not be powered above 2.7V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. 800mV should be the lowest voltage fed to the electronic component. For this multiplexer to operate, 10μA current would be sufficient. A voltage of 0.8V~2.7V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 10μA on the multiplexer may cause damage. It is possible to transfer data over a 198MHz-bandwidth.

SN74AUC2G53YZTR Features

2 Channels
Switch Circuit: SPDT
10μA Supply Current
-3db Bandwidth: 50MHz
Bandwidth: 198MHz

SN74AUC2G53YZTR Applications

There are a lot of Texas Instruments SN74AUC2G53YZTR Analog Switches & Multiplexers ICs applications.

• Sample-and-hold systems
• Access Concentrators
• Data Acquisition Systems
• USB 1.1 signal switching circuits
• Audio and video routing
• MP3 players
• SONET/SDH ADM
• Fiber In The Loop (FITL)
• Precision data acquisition
• Relay replacements