SN74F74NSRE4 Overview
The package is in the form of SOP. As part of the package Tape & Reel (TR), it is embedded. In the configuration, TTLis used as the output. The element count is 2 . 14terminations have occurred. It is powered by a voltage of 5V . A device of this type belongs to the family of F/FAST. It is mounted in the way of Surface Mount. There are 14pins on it. The clock edge trigger type for this device is Positive Edge. An electronic part with 1bits has been designed. A reliable performance of this D flip flop makes it well suited for use in TAPE AND REEL. A power supply of 5Vis required to operate it. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. There are no output lines on the JK flip flop. 1input lines are available for you to choose from. A high level output current of 20mAis set. In the low level output current setting, the current is set to 1mA. Ideally, the operating temperature should be below 70°C. If the operating temperature is higher than 0°C, the system should operate properly. In order for it to operate, a supply voltage of 4.5Vis required. A maximum voltage of 5.5V can be provided by it. This frequency can be achieved at 145MHz. There is a logic IC D FLIP-FLOP used in the D flip flop. It has 2 functions. 14pins are available on this JK flip flop. With an output current of 20mA, this flip flop offers maximum design flexibility.
SN74F74NSRE4 Features
Tape & Reel (TR) package
14 pins
1 Bits
5V power supplies
2 Functions
14 pin count
SN74F74NSRE4 Applications
There are a lot of Texas Instruments
SN74F74NSRE4 Flip Flops applications.
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
- Frequency division
