SN74LV174APWRE4 Overview
In the form of TSSOP, it has been packaged. There is an embedded version in the package Tape & Reel (TR). The number of terminations is 16. An input voltage of 2.5Vpowers the D latch. In this case, the D flip flop belongs to the LV/LV-A/LVX/Hfamily. There is an electronic component mounted in the way of Surface Mount. 16pins are included in its design. This device's clock edge trigger type is Positive Edge. The part you are looking for is included in FF/Latches. It is designed with a number of bits of 6. Using 7 circuits, it is highly flexible. In view of its reliability, this D flip flop is a good fit for TAPE AND REEL. In order for the device to operate, it requires 3.3V power supplies. The JK flip flop is with 1 output lines to operate. The number of input lines is 2. In this case, the high level output current is set to -12mA. 12mAis set as the low level output current. There should be a temperature below 85°Cduring operation. In order for the system to operate properly, the temperature should be higher than -40°C. The RS flip flop is designed to operate with a minimal supply voltage of 2VV. There is a maximum voltage support of 5.5V. A frequency of 180MHzcan be achieved. D FLIP-FLOPis the logic IC it uses. There are 1 functions available on this T flip flop. A total of 16 pins are present on this device. Its output current of 12mA allows for maximum design flexibility.
SN74LV174APWRE4 Features
Tape & Reel (TR) package
16 pins
6 Bits
3.3V power supplies
1 Functions
16 pin count
SN74LV174APWRE4 Applications
There are a lot of Texas Instruments
SN74LV174APWRE4 Flip Flops applications.
- Counters
- Frequency Dividers
- Shift Registers
- Storage Registers
- Bounce elimination switch
- Data storage
- Data transfer
- Latch
- Registers
- Memory
