SN74HC112DT Overview

The flip flop is packaged in a case of 16-SOIC (0.154, 3.90mm Width). D flip flop is embedded in the Tape & Reel (TR) package. T flip flop uses Differentialas its output configuration. There is a trigger configured with Negative Edge. Surface Mountis occupied by this electronic component. A voltage of 2V~6Vis used as the supply voltage. Temperature is set to -40°C~85°C TA. A flip flop of this type is classified as a JK Type. In terms of FPGAs, it belongs to the 74HC series. You should not exceed 60MHzin the output frequency of the device. T flip flop consumes 4μA quiescent energy. It has been determined that there have been 16 terminations. The 74HC112 family contains this object. Power is supplied from a voltage of 5V volts. There is 3pF input capacitance for this T flip flop. It belongs to the family of electronic devices known as HC/UH. This electronic part is mounted in the way of Surface Mount. 16pins are included in its design. The clock edge trigger type for this device is Negative Edge. There is a base part number FF/Latchesfor the RS flip flops. Vsup reaches its maximum value at 6V. Normally, the supply voltage (Vsup) should be above 2V. To achieve this superior flexibility, 2 circuits are used. This D flip flop is well suited for TR based on its reliable performance. If high efficiency is to be achieved, the supply voltage should be maintained at 5V. This T flip flop features a maximum design flexibility due to its output current of 5.2mA. In order to operate, the chip has 3 output lines.

SN74HC112DT Features

Tape & Reel (TR) package
74HC series
16 pins

SN74HC112DT Applications

There are a lot of Texas Instruments SN74HC112DT Flip Flops applications.

• Event Detectors
• Asynchronous counter
• Individual Asynchronous Resets
• Common Clocks
• Digital electronics systems
• ESD protection
• Buffered Clock
• Bounce elimination switch
• Registers
• Control circuits