SN74HC574DWRE4 Overview

20-SOIC (0.295, 7.50mm Width)is the packaging method. It is included in the package Tape & Reel (TR). In the configuration, Tri-State, Non-Invertedis used as the output. There is a trigger configured with Positive Edge. Surface Mountis occupied by this electronic component. The supply voltage is set to 2V~6V. A temperature of -40°C~85°C TAis considered to be the operating temperature. This electronic flip flop is of type D-Type. This type of FPGA is a part of the 74HC series. A frequency of 40MHzshould be the maximum output frequency. D latch consists of 1 elements. As a result, it consumes 8μA quiescent current and is not affected by external forces. Currently, there are 20 terminations. D latch belongs to the 74HC574 family. The power source is powered by 5V. This JK flip flop has a 3pFfarad input capacitance. In this case, the D flip flop belongs to the HC/UHfamily. There is an electronic component mounted in the way of Surface Mount. There are 20pins on it. It has a clock edge trigger type of Positive Edge. This RS flip flops is a part number FF/Latches. There are 8bits in its design. There is a 6Vmaximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 2V. Despite its superior flexibility, it relies on 8 circuits to achieve it. Due to its reliability, this T flip flop is well suited for TAPE AND REEL. It runs on 2/6Vvolts of power. A total of 2ports are embedded in the D flip flop. For high efficiency, the supply voltage should be kept at 5V. Its output current of 7.8mAallows for maximum design flexibility. It has 3lines.

SN74HC574DWRE4 Features

Tape & Reel (TR) package
74HC series
20 pins
8 Bits
2/6V power supplies

SN74HC574DWRE4 Applications

There are a lot of Texas Instruments SN74HC574DWRE4 Flip Flops applications.

• Patented noise
• Asynchronous counter
• Convert a momentary switch to a toggle switch
• Frequency Dividers
• Bus hold
• Test & Measurement
• Cold spare funcion
• Memory
• Buffer registers
• Differential Individual